Contact Us
Position:Home >

3D Printing Conceptional Car

2015/3/26 12:12:58
Introduction

 

Currently, foreign countries have developed a 3D printing two cars, but a long production cycle, expensive raw materials, and the size is relatively small, Sanya Sihai section 3D printing company developed the concept car, the body all for 3D printing is made using a common chassis design electric drive, it has the following four characteristics:

First, print a large weight, in order to test the material handling capacity of the printer, print the total weight of 500KG, 3D printing is far greater than foreign cars, proved a huge material handling capacity of the printer.

Second, the print speed, print volume 500KG total print time for five days, every day about 100KG of printable material.

Third, you can print any high complexity of modeling, the use of technology to support large-scale water-soluble material, and any complex hollow structure uniform printable, so the body is inside the grid structure to optimize the structural strength.

Fourth, the material strength while maintaining a low cost (15 yuan / KG) of high strength and toughness, the cost is only one tenth of the carbon fiber, and strength can reach half of the carbon fiber.




More Products
宝石与城市送彩金 今天3d预测 Playboy黄金 足球比分预测公式 3d试机号口诀 pc蛋蛋 东莞按摩实拍 足球即时比分网下载 山东11选5玩法 亿源策略配资 成都站街女绿化带做生意 东方61开奖结果 男女黄色片段 广东赖子麻将怎么玩 海南4+1 家庭教师日本av片在线观看 排列三前500期